Spring Cone Crusher

Specifications
Overview
Working Principle

Notice: Any change of technical data shall not be advised additionally.

Spring Cone Crusher breaks material by squeezing or compressing it between convex and concave shaped surfaces covered by manganese as the wear surface. Normally used as the second or third stage crusher. The cone crusher has been developed to crush high or medium hardness material ,such as iron ore ,copper ore, limestone, quartz, granite, and sand stones, ect.

The spring cone crusher has been developed to crush feed materials into desired end products efficiently, reliably and economically.This series offers the highest crushing efficiency and end product quality with the lowest cost per tone production.

The safety system uses dry oil and water as two kinds of sealed formation to make plaster powder and engine oil separate to make sure reliable performance. The type of crushing chamber depends upon size of feeding and fineness of crushed product. The standard type (PYB) is applied to medium crushing, the medium type is applied to medium or fine crushing and the short head type is applied to fine crushing.

Features:

1. The spring cone crushers crushes by the change of the gap in the crushing cavity;
2. High reduction ratio, high performance, low power consumption, and uniform size products.

Cone crusher crushes materials by the working surface between the movable cone and fixed cone. So it is more advanced and efficiency efficient than jaw crusher. The movable cone is supported by spherical bearing and fixed on an hanging erect shaft which is set in the eccentric sleeve, and the sleeve is set on the stopping and pushing bearing. The movable cone and erect shaft are driven by the eccentric shaft sleeve together. The eccentric shaft sleeve is driven by horizontal shaft and fimbriated gear, and the wheel of the conveyor belt is driven by motor through v-belts. The lower part of vertical shaft is installed in the eccentric sleeve. When the eccentric sleeve rotates, there is a conical surface lined out by the shaft. When the movable cone comes near the fixed cone, rocks are grinded into pieces, when the movable cone leaves, grinded materials is discharged from the discharge hole. The fixed cone can be ascended or descended by adjusting setting to adjust the width of discharge hole, consequently the output size is determined adjusted.