Closed-circuit Mobile cone Crusher Crushing ...

Capacity of the crusher

Capacity is subject to feeding method, material size, size of final product, material nature, temperature, etc. the range is wide. The capacity is under certain conditions.

Change of mortar

There are u-shaped bolts on the adjusting ring. Fill zinc alloy into the space. When installing or changing the mortar, after 6-8 hours' operation, check the fastening conditions and screw the U-shaped bolts again.

Change of the crusher inner wall

The Cone crusher inner wall is fixed to the cone crusher body through a cone end. There is zinc alloy between them. When installing or changing the inner wall, after 6-8 hours' operation, check the fastening conditions. If there is loose, fasten it.

Mesh of gears

The friction of round plate changes the gap between gears. To make the gears properly meshed, clients are required to put a mat on the bottom cover. The thickness of the mat should equal to the friction of the round plate.

Bowl-shaped bearing and sealing device

When installing the bowl-shaped bearing, make sure the oil seal is not damaged by the steel cable.

When assembly, scrape the spherical surface to ensure the space between crushing cone and the spherical surface is kept within 0.35-0.5mm.

The bowl-shaped tile is fixed to the bowl-shaped bearing support through lock pins to prevent the tile rotate in circle.

The bowl-shaped bearing support and the frame are fixed together by lock. If there is space between the support and the frame, deal with it immediately.

The cylinder liner and the frame is the third transient assembly.

To avoid the liner rotating, the upper part of liner is filled with zinc alloy. When changing new liner, make sure it is according to the practical size because the after long time's operation and assembly, some changes may happen to the crusher. If the space is too large, the liner will be broken.

Conic liner

The cone cover and the eccentric shaft should wring each other. Fill in some zinc alloy to stop the cover rotating. The space should be full of zinc alloy. The cover may change its shape due to the hot zinc alloy, so check the size of d1, d2 and B of a new cover. If it is incorrect, correct it. When making spare parts, make sure it is fit for the practical size of the inner diameter of eccentric shell.