lubrication for jaw crusher in Russia Daily Use
Jaw crusher maintenance is a more important topic, some of the material is to be worn, then, how it can reduce the wear and tear of it, there is an effective method, that is, add lubricating device.
Our design and production are of high position both at home and abroad. 1, The checks to prove that mechanical transmission part is normal, before the start. 2, The machine is started under load conditions only in the case of promises. 3, Starts, if found to have abnormalities, should immediately stop running, you must identify and eliminate non-normal, then re-start the crushing machine. Jaw Crusher Maintenance And Using.
1, lubrication components: oil lubricated parts department used to facilitate the injection mechanism lubrication points, lubricating the machine a total of four points, respectively, for the four bearing place. Manual pump dry oil lubrication. The oil added to the manual pump, exhaust valve open, shake the handle, oil by pipeline to the oil into the lane, to the oil and then split into the lubrication point, the lower part of the hand pump valve pull into another position, swing handle, thus completing the full refueling procedure. Maximum working pressure hand pump is 20mp, if more than this pressure relief valve hand pump oil spill breakdown insurance piece, pressure drop, thus protecting other lubrication components from damage. This form of refueling convenience, but you should check the lubrication flow of the pipeline.
Lubrication: In order to ensure the normal operation of the machine and prolong the life of all, you should regularly oiling lubrication. Join the bearing lubricant should be 50-70% by volume, every 3 to 6 months to replace one. When changing the grease, clean gasoline or kerosene application carefully cleaned parts bearing raceways, cleaning should open bearing decentralization hole. The machine adopts grease applied based on the location of the machine use, climate and other conditions to determine, generally can be calcium-based, sodium, calcium or sodium based grease, the grease in the drier, can be used to coordinate the use of thin oil and grease . Between the bracket and the bracket pad just in the assembly or maintenance, coupled with the right amount of grease to place in their joints.