MTW-Z European Trapezium Mill is new product researched and developed by LIMING based on ordinary European type grinding mill. Because of more advanced idea and more reliable performance, it has been an intelligent key to the mill market.
Applications: Feldspar, calcite, limestone, talc, barite, rare earth, marble, bauxite, phosphate ore, iron oxide red, dolomite, granite, bitumite, anthracite, lignite, kaolin, bentonite, gypsum.
1.The power is strong and bevel gear drives overall. The transmission ratio is more accurate and transmission chain is reduced. Energy loss is reduced and efficiency is improved.
2.Both spindle drive system and fan transmission system adopt dilute oil lubrication, and the oil will be changed every 4 months. Oil exchange cycle is long and maintenance frequency is less.
3.New hanging type cage classifier makes output size adjustable and powder collecting efficiency improved.
4.The capacity reach up to 50t/h, which is superior to other grinding machines’.
5.This machine has got many national patents with advantages of stable running and reliable performance. Besides, it has got environmental protection certification as industrial product. There is little duct and noise during grinding process, which can satisfy the requirements of national environmental protection.
The system consists of grinding mill, separator, air blower, jaw crusher, vibrating feeder, hopper, dust collector, pipe, powder collector, electric cabinet, motors, etc.
Big lump materials are crushed to required size by jaw crusher, then elevated to buffering hopper through elevator, after that fed into the mill to be ground. Materials are to be ground between ring and rollers, and move up with the air flow, those particles which cannot pass the separator will fall down and be ground again, while others will be collected as finished product. Air flow passing through separator will go to the air blower for recycling, it's a closed system.
The main machine should run smoothly without abnormal noise. The temperature of the bearing chamber should not exceed 50℃.
After 30 minutes of testing, stop the machine and tighten the bolts in turn again. Then we can use it.
After normal operation, check once a week to avoid loosening bolts.
1000 engineers will always provide service for your project
Give clear solutions
Rush to customer site
Solve the problem completely
Thank you for your interest in Liming Heavy Industry. If you want to learn more about our Crushers and Industrial grinding mills, Contact us Now to find out what we can do for you next project !